Digico Optocore V221 Uživatelský manuál

DiGiCo Optocore V221A1-1Appendix ADiGiCoOptocore V221For SD Rack Optocore OperationIssue E - May 2014

DiGiCo Optocore V221A1-10Next, go to Setup/Audio Sync and set sync to Optocore. Please note that all consoles on the network must be running at thesa

DiGiCo Optocore V221A1-11NOTE: Changing card allocations with these buttons is only possible if the Optocore Setup button is pressed firstNOTE: You ma

DiGiCo Optocore V221A1-12A2.1.3 Audio Sync...In standard operation, all Optpcor

DiGiCo Optocore V221A1-13The simplest way to create the Console Opto Receive Ports is to press the Conform All Ports button on all the other consoles

DiGiCo Optocore V221A1-14A3.2.1 Setting up a Dual Loop System ...Each console and rack should have its Optocore n

DiGiCo Optocore V221A1-15A3.2.4 Single Loop Console on Loop 2...SD8, SD9, SD10 and SD11 consoles are only able to

DiGiCo Optocore V221A1-2

DiGiCo Optocore V221A1-3Contents (Appendix A)A1.1 Optocore V221 - Introduction ...A1-4A1.1.1 System Ov

DiGiCo Optocore V221A1-4A1.1 Optocore V221 - IntroductionA1.1.1 System Overview ...The new

DiGiCo Optocore V221A1-5A1.1.2 Opto V220 (DiGiRacks) and Opto V221 (SD Racks)...SD Series consoles are now capable of operating with either on

DiGiCo Optocore V221A1-6Device Type=DiGiRackChange to SD RackAfter creating a new Snapshot - Change Device Type to SD RackNow Conform this rack to rec

DiGiCo Optocore V221A1-7A1.1.4 Replacing SD Racks with DiGiRacks ...If you are connecting racks with Optocore and your se

DiGiCo Optocore V221A1-8A2.1 The Audio IO PanelA2.1.1 Layout ......Port Lis

DiGiCo Optocore V221A1-9All SD hardware must be running with the same Fibre Speed. The default setting is 2G. The Current Setting can be found in ei